CCTV & Electronic Security — Install, Monitor, Maintain

What's included

Installed to be used, not just to be seen

Most CCTV failures are discovered after an incident: camera facing the wrong way, recording overwritten, or a hard disk that died months ago. Our scope is built around preventing exactly that.

Site survey and camera plan — how many cameras, of what type, at what height and covering which line of sight, agreed on paper before purchase.
Supply and installation — cameras, DVR/NVR, storage, PoE switches, cabling, conduit and power backup, with tidy dressing.
Correct storage sizing — retention period agreed upfront (typically 15–30 days) and the disk sized for it, not guessed.
Mobile and desktop viewing set up on your devices, with a walkthrough for the people who will actually use it.
Access control and alarms — biometric or card readers, boom barriers, door controllers, intrusion and fire-panel integration where needed.
Handover documentation — camera layout drawing, device list with serial numbers, warranty papers and login credentials handed to you in writing.
Annual maintenance contract — scheduled preventive visits, health check of every camera and disk, plus a stated fault-response time.
Footage retrieval support — assistance in exporting clips when you need them for an insurance claim or police complaint.

Systems we install

What we can put on your site

CCTV surveillance

HD and IP camera systems — dome, bullet, PTZ and varifocal — with DVR/NVR, sized storage and remote viewing. Indoor, outdoor and low-light options specified per position.

Access control

Biometric, RFID card and PIN-based door access, turnstiles and boom barriers, with attendance export where you want access data to feed payroll.

Intrusion alarms

Motion sensors, door and shutter contacts, panic buttons and hooters, with configurable alert calls to your supervisor and our control room.

Video door phones & intercom

Entry-point verification for societies, offices and clinics — so the person at the gate is seen before the gate is opened.

Annual maintenance (AMC)

Preventive visits on a fixed schedule, camera-by-camera health check, disk and backup verification, plus a documented fault-response commitment.

Guard + camera combined

Cameras placed to support the guard post rather than duplicate it, so weekly supervisor visits and your footage cover the same blind spots.

Honest advice

Fewer cameras in the right places beats more cameras everywhere

We would rather quote eight well-placed cameras that hold 30 days of footage than sixteen that overwrite in four.

Coverage before count

Entry and exit points, cash and stock areas, loading bays and blind corners first. Corridors and open ground rarely justify a camera each.

Retention before resolution

A theft is often noticed a fortnight later. Footage that has already been overwritten is worth nothing, however sharp it was.

Maintenance before expansion

Before adding cameras, we check that the existing ones are recording. Roughly a third of the systems we inspect have at least one dead channel.

How it works

Enquiry to deployment in four steps

Every stage has a stated turnaround, so you always know what happens next.

1

Enquiry

You share the requirement. We call back, and visit the site free of cost if that helps size it properly.

Within 4 hrs

2

Verification

We shortlist staff and complete police verification, ID, address and previous-employer checks before anyone is offered.

24–36 hrs

3

Deployment

Uniformed, briefed staff report on post with a duty chart, attendance register and emergency contact list.

Within 48 hrs

4

Ongoing support

Supervisor visit once a week, monthly attendance report and a named account manager for escalations.

Every month

Want a camera plan before you spend?

We'll survey the site, mark the positions on a layout and quote against that plan — so you can compare like for like with any other vendor.

Request a CCTV survey Call now